5L 10L 20L Stainless Steel Lab Electric Distilled Water Device Distiller Machine

5L 10L 20L Stainless Steel Lab Electric Distilled Water Device Distiller Machine

1. Use

Laboratory water distiller uses electric heating method to produce steam with tap water and then condensing to prepare the distilled water. For laboratory use in health care, research institutes, universities.

2. The main technical parameters

1. structural features

This instrument is mainly composed by the condenser, evaporator boiler, heating tube and the control section. The main materials are made of stainless steel sheet and stainless steel seamless pipe,with good looks. Electric heating part of the immersion heating pipe, high thermal efficiency.1, condenser part: the water vapor becomes into distilled water by hot and cold exchanging through this device.It is also demountable.2, evaporation boiler part:when the water level in the evaporation boiler exceeds the overflow funnel outlet, the water will automatically overflow from the overflow pipe on the overflow funnel. Evaporation boiler is detachable,easy to wash the pot scale. There is the release valve at the bottom of the evaporation boiler, easy to drain off the water or replace the water storage at any time.

3, the heating tube parts: the immersion heating tube installed in the bottom of the evaporation boiler, heat water and get the steam.4, the control section:the heating of the electric tube or not is controlled by the electrical control section. Electrical control section is composed of the AC contactor, the water level sensor etc.

2. installation requirement

After open the carton,please read the manual first, and install this water distiller according to the diagram.The equipment needs fixed installation use, while paying attention to the following requirements:1, Power: the user should Connect power supply according to the product nameplate parameters, should use the GFCI at the power place(must be installed in the user’s circuit), the shell of the water distiller must be grounded. To ensure the safe use,the wiring plug and socket should be allocationed, according to the electric current. (5 liters, 20 liters: 25A; 10 liters: 15A)

2, water: connect the water distiller and the water tap by the hosepipe. The exit of the distilled water should be connected the plastic tubing (tube length should be controlled in 20CM),let the distilled water inflow into the distilled water container.

3.Use method

1, After the power and water have been installed,it is ready to use.2, Close the release valve first, open the water valve, so that the tap water from the feeding water faucet goes by the condenser, and then from the return pipe injects to the evaporation boiler (return pipe must be aligned the hole of the adding water cup, to ensure that the flow enter the evaporation boiler normally, the water must not rush to the water level sensor directly), until the water comes up to the overflow funnel,there is water overflow smoothly, turn off the water.

3.Turn on the power,when the water in the evaporation boiler is closed to the boiling (can hear the cuckoo sound), re-open the inlet valve, with the observation the return water pipe water temperature (approximately 80 ° C). Adjust the water faucet to control water injection to be appropriate. At this point,there is cooling water discharges from the overflow funnel, when the water in the evaporation boiler begins to boil, in order to ensure that the distilled water output, must ensure the supply of cooling water (cooling water is about 8 times that of distilled water production, only part of the cooling water is supplemented to the evaporation.