laboratory water jacket incubator

laboratory water jacket incubator

1、Preparation before use

The product should work in the following conditions of use:

1.1, ambient temperature: 4 ~ 40 ° C, relative humidity: 85% or less;

1.2, power supply: 220V ± 10%; 50Hz ± 10%;

1.3, atmospheric pressure: (86 ~ 106) kPa;

1.4, there is no strong vibration source and strong electromagnetic field around;

1.5, should be placed in a stable, level, no serious dust, no direct sunlight, no corrosive gas in the room;

1.6. Keep a space of 50 cm around the product.

1.7. Reasonable placement, adjust the position and quantity of the shelf, and the items put into the cabinet, it is necessary to keep a certain gap between the upper and lower sides, and the shelf is not bent by the weight.

2, power on. (If use the fan to turn on the fan switch)

2.1, power on, low water level alarm light, accompanied by buzzer sound.

2.2. Connect the water inlet pipe to the water inlet. Add pure water slowly to the tank (note: people can’t leave, to prevent excessive water overflow).

2.3. When the low water level warning light is extinguished, wait for about 5 seconds to stop adding water. At this time, the water level is between high and low water levels.

2.4. If too much water is added, there will be water overflow in the overflow pipe.

2.5. Pull the drain pipe out about 30 cm and pull out the drain plug.

2.6. Discharge the drain plug 2 seconds after draining until the overflow pipe stops overflowing.laboratory water jacket incubator,water jacket incubator.

Main technical data

Our company is specialized in producing drying boxes, incubators, ultra-clean worktables, disinfecting pots, box-type resistance furnaces, adjustable universal furnaces, closed electric furnaces, electric heating plates, constant temperature water tanks, three water tanks, water baths and electric distilled water. factory. The quality of the products is reliable and three bags are implemented.