main_banner

news

Egypt customer orders water distillers laboratory

 

Egypt customer orders water distillers

 

  1. Use

This product uses electric heating method to produce steam with tap water and then condensing to prepare the distilled water. For laboratory use in health care, research institutes, universities.

  1. The main technical parameters

Model

DZ-5L

DZ-10L

DZ-20L

specification

5L

10L

20L

Heating power

5KW

7.5KW

15KW

Voltage

AC220V

AC380V

AC380V

capacity

5L/H

10L/H

20L/H

connecting line methods

single phase

Three phase and Four wire

Three phase and Four wire

  1. structural features

This instrument is mainly composed by the condenser, evaporator boiler, heating tube and the control section. The main materials are made ​​of stainless steel sheet and stainless steel seamless pipe,with good looks. Electric heating part of the immersion heating pipe, high thermal efficiency.
1, condenser part: the water vapor becomes into distilled water by hot and cold exchanging through this device.It is also demountable.
2, evaporation boiler part:when the water level in the evaporation boiler exceeds the overflow funnel outlet, the water will automatically overflow from the overflow pipe on the overflow funnel. Evaporation boiler is detachable,easy to wash the pot scale. There is the release valve at the bottom of the evaporation boiler, easy to drain off the water or replace the water storage at any time.

3, the heating tube parts: the immersion heating tube installed in the bottom of the evaporation boiler, heat water and get the steam.
4, the control section:the heating of the electric tube or not is controlled by the electrical control section. Electrical control section is composed of the AC contactor, the water level sensor etc.

 

5. installation requirement

After open the carton,please read the manual firstand install this water distiller according to the diagram.The equipment needs fixed installation use, while paying attention to the following requirements:
1, Power: the user should Connect power supply according to the product nameplate parameters, should use the GFCI at the power place(must be installed in the user’s circuit), the shell of the water distiller must be grounded. To ensure the safe use,the wiring plug and socket should be allocationed, according to the electric current. (5 liters, 20 liters: 25A; 10 liters: 15A)
2, water: connect the water distiller and the water tap by the hosepipe. The exit of the distilled water should be connected the plastic tubing (tube length should be controlled in 20CM),let the distilled water inflow into the distilled water container.

water distiller

 

 

PHOTO-1

 

工厂流程1

2


Post time: Jan-20-2024
Write your message here and send it to us